Buyer must contact the seller to schedule a removal appointment, before access will be granted to the merchandise. Buyer solely responsible for removal of items from seller's premises within (10) Business Days after bid approval. Please make sure you are paying the correct amount, per your means of payment.

Subsequent overpayments will have a $35 administrative fee deducted from the remittance amount (or charged against) the invoiced buyer. Individuals who pay the non-discounted rate with cash or guaranteed funds will have a one-time, courtesy refund issued for the overpayment. Please make sure your payment amount reflects your choice of payment method. Successful High Bidders: Please note when you are provided an invoice to pay, there are two different payment amounts.ġ) A non-discounted rate for payments made with credit/debit cards, and,Ģ) A discounted rate for payments made with certified funds cash, bank transfer, guaranteed funds or money order. Out-of-State Buyers: Buyers outside of New York State need to send us a completed NY State DTF Form before we can remove sales tax from their invoices. GENERAL QUESTIONS: email Methods: We accept cash, cashier's check, wire/bank transfer and credit cards. Payment questions? Please Call: 1-80 x201. Please mail payment in certified funds or money order to: Auctions International, 11167 Big Tree Road, East Aurora, NY 14052. After you receive the invoice, you will have five (5) business days to get your payment mailed to our office, or your account will be suspended, and the item will be awarded to the backup-bidder, or re-listed. The key here was persistence and maintaining a ‘you catch more flies with honey’ attitude.Fingers crossed that this fixes the issue, and it will be a permanent fix.Payment Terms: Payment will be due immediately upon notification of seller approval by email invoice, after the Seller approves the bids. Long story short, Black and Decker/DeWalt is sending me a new shaft and a couple of needed replacement nuts,washers and screws, all at their expense,including shipping. I fought my way to technical rep that knew what she was talking about and realized that I did,too. OK, I got on the phone to DeWalt and initially hit a bit of a brick wall.”You must take it to an authorized service center,” etc. Those type of push nuts should not be reused once the shaft has been removed.

The front part of the shaft fits into a push nut that fits into the inside of the table. Six of the screws had lock tite on them,but the two towards the front had no thread lock and had loosened, which probably played a major part as the cause of the failure. On top of that there are four clips holding the shaft assembly down by eight screws. I took the DWE 7480 apart this morning and found the front part of the shaft assembly was bent.

Dewalt table saw fence